➔ We recommend replacement only when the glass cannot be repaired;

➔ We use professional-grade auto glass repair materials;

➔ We follow manufacturer-approved installation procedures for every replacement;

➔ All work is backed by a warranty.

📊 Important: The sooner a chip is repaired, the greater the chance of saving the original windshield without replacement.

Windshield Chip & Crack Repair

We repair chips and small cracks in windshields using a high-quality resin that restores strength and helps prevent further cracking. Most repairs take just 30–60 minutes.

Auto Glass Replacement

If a crack is too large or located within the driver's direct field of vision, the glass should be replaced. We replace windshields, side windows, and rear windows using the correct installation procedures. In most cases, your vehicle will be ready for pickup within a few hours.

Glass Polishing

Glass polishing removes light scratches, wiper marks, and other signs of everyday wear. Using professional polishing compounds and equipment, we restore glass clarity and improve visibility.

Side Mirror Repair & Replacement

We repair exterior side mirrors by replacing the mirror glass, repairing adjustment mechanisms, and fixing heated mirror faults. When necessary, we can replace the entire mirror assembly.

Sensor Calibration After Windshield Replacement

After replacing a windshield, we inspect and, if necessary, calibrate the rain sensor, light sensor, and other systems connected to the windshield. This ensures all electronic safety systems continue to operate correctly.

Pricing

The cost of chip and crack repair depends on the type, size, and location of the damage.

Frequently Asked Questions

Can every windshield chip be repaired?

No. Repair is only possible for small, repairable chips. Large or complex damage usually requires windshield replacement.

How soon should a chip be repaired?

The sooner, the better. Ideally, it should be repaired within the first few days before dirt and moisture enter the damaged area.

Will the repaired chip still be visible?

The damage becomes much less noticeable after repair, but the glass will not look completely new. The main purpose of the repair is to stop the crack from spreading and restore the structural strength of the windshield.

Car Headlight & Lighting Services

Below are our most popular headlight services and prices in Vilnius:

➔ Headlight Polishing — from €20 per headlight. We remove oxidation, cloudiness, and surface scratches, restoring transparency and light output. This significantly improves visibility without replacing the headlights.

➔ Headlight Alignment — from €15 (both headlights). We precisely adjust the beam angle and direction using professional alignment equipment. Proper headlight alignment is essential for safe driving and is required to pass a technical inspection.

➔ Bulb & Lighting Component Replacement — from €10. We replace low beam and high beam bulbs, parking lights, turn signal bulbs, and other lighting components. We select bulbs that match your vehicle's specifications.

➔ Headlight Repair & Replacement — from €40. We repair damaged housings, broken mounting points, water leaks, and electrical faults. Whenever possible, we restore the headlight instead of replacing it completely.

➔ Headlight Sealing — from €25. We eliminate condensation and moisture inside the headlight by restoring the housing and seal integrity.

We recommend a repair solution only after a professional inspection.

Common Problems We Solve

• headlights have become dim or provide uneven lighting;
• headlights are aimed too high or too low;
• condensation or moisture appears inside the headlights;
• individual lighting components are not working;
• the vehicle fails the technical inspection due to incorrect headlight operation.

If your headlights no longer provide proper illumination or are not working correctly, don't postpone the inspection. Good lighting has a direct impact on driving safety and comfort.

Frequently Asked Questions

Can headlights be restored without replacing them?

Yes. In many cases, professional polishing and clarity restoration are enough.

How long does headlight polishing take?

Usually between 30 and 60 minutes.

Is headlight alignment necessary after replacing bulbs?

Yes, it is recommended. Even a slight misalignment can reduce lighting performance and visibility.

Why do headlights become foggy inside?

In most cases, this is caused by a failed seal that allows moisture to enter the headlight housing. A professional inspection and resealing will restore proper protection.

⚡️Repair time: from 1 hour to 2 days (depending on the complexity of the repair).

⚡️Services: diagnostics, heater core flushing, repair or replacement of heating system components (heater core, thermostat, blower motor, air blend doors, cooling system components).

⚡️Warranty: provided for all work performed and installed parts. We also provide a photo and video report.

⚡️Experience: over 20 years.

How Diagnostics and Repair Are Performed

1. First, we check the coolant level and circulation, compare the temperature of the heater core inlet and outlet hoses, and evaluate the temperature of the air coming from the dashboard vents.
2. Next, we inspect the blower motor and air blend doors responsible for airflow distribution and temperature control. If necessary, we also check the thermostat and other cooling system components.
3. After the inspection, we accurately identify the cause of the problem—such as a clogged heater core, air trapped in the cooling system, faulty blend doors, or another issue—and recommend the most effective repair solution.

In many cases, the problem can be solved without replacing the heater core. A professional flush is often enough to restore proper system performance.

The heater itself is not always the source of the problem. The fault may lie in the cooling system or the climate control mechanism, which is why proper diagnostics are essential.

Car Heater Repair Prices

The final price depends on the vehicle and the complexity of the repair. We always agree on the cost in advance, with no hidden fees, taking into account your vehicle's condition and your budget.

Why Choose Our Auto Service in Vilnius

★ Accurate diagnostics;

★ We recommend replacement only when repair is not possible;

★ We clearly explain what has failed and why;

★ Repair costs are agreed upon before any work begins;

★ Photo and video reports are provided.

If your car heater is not working properly or isn't producing enough heat, don't delay the inspection. In many cases, early diagnostics help solve the problem faster and at a lower cost.

Contact us today—we'll inspect your vehicle's heating system and recommend the best solution.

Frequently Asked Questions

Why is my car heater not blowing warm air?

The most common causes are a clogged heater core, air trapped in the cooling system, or faulty air blend doors. The problem may also be related to the thermostat or poor coolant circulation.

Can the heater core be repaired instead of replaced?

Yes. In many cases, flushing the heater core and restoring proper coolant circulation is enough. Replacement is only necessary if the heater core is severely clogged or damaged.

How long does the repair take?

Most repairs take between 1 and 3 hours. More complex repairs may require several days.

Why does my car smell like coolant inside?

This usually indicates a leaking heater core or one of its connections. A professional inspection is required to locate the source of the leak accurately.

Why Choose Us:

★ Wide range of services in one place.

★ Over 20 years of experience.

★ We service all vehicle makes.

★ Warranty with photo and video reports.

★ Fast turnaround times.

If your brakes have become less effective or you've noticed unusual noises, don't delay an inspection. In many cases, the problem can be fixed quickly and at a reasonable cost when addressed early.

Brake System Services

Before carrying out any repairs, we perform a complete brake system inspection to accurately determine the cause of the fault.

We check brake pads and brake discs, brake calipers, brake fluid level and condition, braking performance. If necessary, we also inspect the ABS system and the hydraulic brake system.

Our brake services include:

1. Brake pad and brake disc replacement. Brake pads should be replaced when the friction material wears down to approximately 4–5 mm or less. Brake discs also have a minimum allowable thickness specified by the manufacturer, either on the disc itself or in the vehicle's technical documentation.

2. Brake disc resurfacing. If the brake discs have uneven wear or cause vibration during braking, they may be resurfaced. This restores the braking surface and can extend the life of the discs, provided they remain within the manufacturer's minimum thickness specification.

3. Brake fluid replacement. Recommended every 2 years or every 40,000–60,000 km.

4. Brake bleeding. We remove air from the brake system to restore proper hydraulic pressure and braking performance. This service is typically performed after repairs or brake fluid replacement.

5. Parking brake (handbrake) service. We inspect cable tension, mechanism operation and braking balance. If necessary, we adjust, clean or replace worn components.

6. ABS diagnostics and repair. We read fault codes, test ABS sensors and check system operation. Repairs range from replacing a faulty sensor to repairing wiring or the ABS control module.

Brake Repair Prices in Vilnius

The final price depends on your vehicle model and the scope of the repair. An accurate quotation is provided after diagnostics.

Common Brake System Problems

Increased Braking Distance

This is most commonly caused by worn brake pads, brake discs or degraded brake fluid. It may also indicate a fault in the hydraulic brake system. A professional inspection is required to determine the exact cause.

Squeaking or Grinding When Braking

Light squeaking may simply be caused by dust or the characteristics of the brake pads, but it can also indicate worn components or uneven brake operation. We recommend checking the brake pads, discs and calipers.

Brake Pedal Vibrates During Braking

This is usually caused by warped or unevenly worn brake discs. In such cases, the discs should be inspected and, if necessary, resurfaced or replaced.

Vehicle Pulls to One Side While Braking

This may be caused by uneven braking force between the wheels, a sticking brake caliper or worn suspension components. Since this affects driving safety, prompt diagnostics are recommended.

Soft or Spongy Brake Pedal

This is one of the most serious warning signs. Possible causes include a brake fluid leak, air in the brake lines or a faulty master brake cylinder. Immediate inspection is strongly recommended.

Brake Fluid Leak

A brake fluid leak is a critical safety issue. Leaks may occur in brake hoses, connections or cylinders. Driving the vehicle in this condition is unsafe and requires immediate repair.

❓ Frequently Asked Questions

How often should the brake system be inspected?

We recommend a brake system inspection every 10,000–15,000 km, or immediately if you notice any symptoms of brake problems.

How long do brake pads last?

On average, 20,000–40,000 km, depending on your driving style and driving conditions.

How can I tell if my brake pads or discs are worn?

Many vehicles are equipped with brake pad wear sensors that alert you when the pads have reached their wear limit.

If your vehicle doesn't have wear sensors, the pads should be inspected visually. When the friction material is reduced to approximately 4–6 mm or less, braking performance begins to decrease and replacement should not be delayed.

Brake discs also have a minimum allowable thickness, specified either on the disc itself or in the vehicle manufacturer's documentation. If the disc is worn below this limit, it must be replaced.

During our inspection, we check all of these components and provide clear recommendations to help maintain safe braking performance and avoid unnecessary future expenses.

When should brake fluid be replaced?

Brake fluid should be replaced every 2 years or every 40,000–60,000 km.

Can I continue driving if the ABS warning light is on?

Yes, but it is not recommended. Your vehicle's standard brakes will continue to work, but the ABS system will be disabled, increasing the risk of wheel lock-up during emergency braking and reducing vehicle control. We recommend diagnosing and repairing the problem as soon as possible.

Diagnostics take 20–40 minutes, and most repairs are completed the same day.

What Problems Do We Solve?

• loud exhaust noise or changes in engine sound;
• exhaust fumes inside the cabin or around the vehicle;
• increased fuel consumption;
• vibrations or unusual noises underneath the car;
• oxygen (lambda) sensor or catalytic converter fault codes;
• burnt-out or damaged muffler and other exhaust system faults.

If the problem isn't repaired promptly, the damage can spread to other parts of the exhaust system, significantly increasing repair costs. In many cases, the issue can be fixed quickly and affordably, so don't delay your visit to our workshop.

Service Description

We begin with a comprehensive exhaust system inspection, checking for leaks, damaged joints, corrosion, cracks, catalytic converter condition and oxygen sensor operation. This allows us to identify the exact cause of the problem and recommend the best solution — repair or replacement.

Depending on the condition of the system, we perform muffler and exhaust pipe welding, replace individual components or install a complete exhaust system. After the repair, you'll receive a photo or video report of the completed work.

Diesel Particulate Filter (DPF) Cleaning

The Diesel Particulate Filter (DPF) is an essential part of the exhaust system that affects engine performance and emissions. When the filter becomes clogged, it can reduce engine power, increase fuel consumption and trigger warning lights.

We provide DPF diagnostics and professional cleaning, as well as an assessment of whether the filter can be restored. In many cases, the filter can be cleaned successfully without replacement, saving you a significant amount of money.

Exhaust System Repair Prices in Vilnius

The final price depends on your vehicle and the condition of the exhaust system. An accurate quotation is provided after diagnostics. We guarantee fair and transparent pricing.

❓ Frequently Asked Questions

Can a muffler be repaired, or does it need to be replaced?

If the damage is localised, such as a crack or minor corrosion, muffler welding is usually sufficient. If the muffler is severely rusted or burnt through, replacement is generally the better option.

How long does exhaust system repair take?

Most repairs, including muffler welding and replacement of individual exhaust components, are completed within about one hour.

How can I tell if the problem is in the exhaust system?

In many cases, the only reliable way is through a professional inspection. We examine the vehicle on a lift, check the exhaust system for leaks, inspect all connections and components, and accurately identify the source of the problem.

Do you provide exhaust welding?

Yes. We carry out muffler, exhaust pipe and exhaust joint welding. It's one of the fastest and most cost-effective repair methods for localised damage.

Should I replace the catalytic converter, or can it be removed?

It depends on its condition. If the catalytic converter is clogged or damaged, both replacement and removal may be possible. After diagnostics, we'll explain the advantages, disadvantages and consequences of each option so you can make an informed decision.

What happens if I don't repair the exhaust system in time?

Small problems can quickly become much more serious. A minor crack may turn into a large hole, exhaust noise increases, engine performance can deteriorate, and the overall repair cost becomes significantly higher.

What are the exhaust system requirements for the vehicle inspection (MOT)?

To pass the technical inspection in Lithuania, the exhaust system must:

• be leak-free and in good condition;
• have no structural damage;
• comply with permitted noise limits;
• meet emissions standards;
• have a functioning catalytic converter and Diesel Particulate Filter (DPF) where originally fitted by the manufacturer;
• have no fault codes related to the exhaust or emissions system.